Dynapower Sure Star SS-1U52ES 500W High Efficiency 1U Power Supply

(0)
Write review
 In stock
$169.00
  • Model
  • SS-1U52ES

Description:

SS-1U52ES 1U 520W High Efficiency Power Supply

 
 

Introduction:
- Introduce the industrial graded SS-1U52ES Series Power Supply.
- Design to fit perfectly into your 1U Rackmount chassis.
- Triple circuit protections and Active PFC. SS-1U52ES is the most compact and versatile 1U Power Supply.
 
* AC Input Voltage Range: 100VAC ~ 240VAC, +/-10%, 47 to 63 Hz.
* INPUT CURRENT:8.0 A ( RMS ) FOR 115VAC /4.0 A ( RMS ) FOR 230VAC.
* Input Power Factor: The minimum power factor at full load shall be 0.98/115V 60 Hz and 0.95/230V 50 Hz.
* Inrush current: 35A MAX. FOR 115 VAC / 55A MAX. FOR 230 VAC.
* DC Output: 520W maximum
OUTPUT VOLTAGE OUTPUT CURRENT REGULATION OUTPUT
MIN ( A ) MAX ( A ) LOAD LINE RIPPLE & NOISE
MAX. [ P-P ]
+5V 0.5 25 ±5% ±1% 60mV
+12V 2 40 ±5% ±1% 120mV
-12V 0 0.8 ±5% ±1% 120mV
+3.3V 0.5 25 ±5% ±1% 60mV
+5VSB 0.1 3.5 ±5% ±1% 60mV
1. Noise Test – Noise bandwidth is from DC to 20 MHz.
2. Ripple frequencies greater than 1MHz shall be attenuated by the measurement System.
3. Add 0.1uF/10uF capacitor at output connector terminals for ripple and noise measurements.
4. The combined total power from 5V & 3.3V shall not exceed 170W.

 
 
• DIMENSION: D200 X W100 X H40.5mm
• COOLING: ONE 40mm DC FANS.
• TEMPERATURE RANGE: Operation 0℃~45℃
• HOLD UP TIME: 16ms at maximum load & normal input voltage
• EFFICIENCY: TYPICAL >80% AT 115VAC, FULL LOAD.
• ATX 12V / EPS 12V
• POWER GOOD SIGNAL: PW-OK is power good signal and should be asserted high by the Power Supply to indicate that +5VDC and +3.3VDC output are above the under voltage thresholds of the Power Supply TTL. compatible signal out with 100ms to 500ms.
• OVER POWER PROTECTION: The Power Supply shall shut down when output power exceeds 110﹪to 160﹪ of full load and require a power on cycle be performed by the operate
• OVER VOLTAGE PROTECTION: Standard on +5.0V, set at 6.5VDC ± 0.75VDC
• SHORT CIRCUIT PROTECTION: A short circuit placed between the DC return and the output shall cause no damage and the Power Supply shall shutdown.
• EMI: FCC CLASS A, CISPR22 CLASS A.
• AGENCY APPROVALS: TO MEET UL, CUL, TUV.
• MTBF: 100,000 hours.
 
20+4 Pin
P4 MB
Peripheral
FDD
8-Pin
SATA
X 1
X 1
X 6
X 1
X 1
X 2